Airbag / SRS Module Reset in Los Angeles, CA

An airbag or SRS module reset clears the crash data and hard codes stored in your vehicle's airbag control module after a collision, so the system can arm again and the warning light turns off.


At JC's Auto Repair Shop Los Angeles, we do this the safe way. We diagnose the whole Supplemental Restraint System, address any deployed or damaged components, and reset the module so your car is genuinely protected again, not just quiet on the dashboard.


Our airbag and SRS services include:


  • SRS Module Diagnosis and Scanning
  • Crash Data and Hard Code Clearing
  • Airbag Warning Light Reset
  • Module Removal, Reset, and Reinstallation
  • Clock Spring and Crash Sensor Inspection
  • Seat Belt Pretensioner Assessment
  • Post Reset Verification and Testing


After even a minor accident, the airbag module writes a permanent record of the event to its memory and locks itself. In that locked state your airbags and seat belt pretensioners may not deploy in a future crash, which is exactly why this cannot be left to a light on the dash. Our experienced technicians restore the system to its factory, pre crash condition so you can drive with real confidence again.


Is your airbag light staying on? Call JC's Auto Repair Shop today at 323 792 1777 or visit our Contact Us page to schedule your SRS diagnosis. Let us make your safety system whole again.

Contact Us

Our Airbag and Air Bag Repair Services


Discover our range of expert services designed to enhance your vehicle's safety. From detailed diagnostics to precise repairs, we ensure every component of your airbag system functions perfectly.


Airbag Light Diagnosis and SRS Scanning

The airbag warning light is the system telling you it has found a fault and shut itself down. The cause could be a failed clock spring in the steering column, a seat occupancy sensor, a corroded connector under a seat, a low voltage event, or crash data stored after an impact. Because a generic code reader often cannot see the SRS system properly, we scan it with equipment that reads the airbag module directly and tells us what the fault actually is before anyone quotes a repair. This is where every honest airbag job starts.


Deployed Airbag Replacement

After a collision, replacing a deployed airbag is only part of the work. The driver and passenger airbags, the steering wheel or dashboard components that housed them, the impact sensors, and often the seat belt pretensioners all need assessment, because they operate as one system and frequently deploy together. We replace deployed airbags with components that meet safety standards and verify the whole restraint system afterward, rather than fitting a bag and leaving the rest untested. This work often runs alongside auto body and collision repair, and we coordinate with that side of the job when your vehicle needs both.


Airbag Module Reset and SRS Module Programming

When a vehicle detects an impact, the airbag control module writes crash data to protected memory and locks itself. Until that data is cleared, the system stays disabled no matter how many new airbags are fitted, and ordinary scan tools cannot erase it. We handle that reset properly and restore the module to its working state. Our dedicated airbag and SRS module reset service covers the crash data and hard code side of this work in more detail if that is specifically what your vehicle needs.


Seat Belt and Pretensioner Repair

Seat belts are part of the same restraint system as your airbags, and they are frequently overlooked. Pretensioners are pyrotechnic devices that fire in a crash to pull the belt tight, and once fired they are spent and will hold an SRS fault until they are dealt with. Beyond that, we repair belts that will not retract, buckles that do not latch or release reliably, and belts that lock up during normal driving. A seat belt that does not retract properly is a daily annoyance that also compromises how the belt performs in an impact, and it is a far smaller job than most people assume.


Airbag Sensor and Clock Spring Repair

Impact sensors sit at the front and sides of the vehicle and tell the module when to deploy. A damaged sensor or a broken wire in that circuit will disable the system and keep the light on. The clock spring, which maintains the electrical connection to the driver airbag while the steering wheel turns, is another common failure point and often shows up alongside horn or steering wheel control problems. Both faults are electrical at heart, which is why our auto electrical repair and maintenance capability matters for airbag work. We also handle related safety electronics such as backup camera and sensor installation.


Airbag Inspection Before You Buy a Used Car

A used vehicle with a disabled airbag system looks identical to one with a working system until you scan it. Cars that have been through an accident and repaired cheaply sometimes have the light hidden rather than the system repaired, and occasionally the airbags were never replaced at all. If you are buying privately or from a small lot, an SRS check is worth doing, and our pre-purchase vehicle inspection covers exactly this.

Signs You Need an Airbag or SRS Module Reset

Knowing when your SRS system needs attention can be the difference between a protected drive and a dangerous one. Here are the most common signs.

  • Airbag Light Stays On After an Accident

    This is the clearest sign of all. If your airbag warning light stayed on after a collision, your module is almost certainly holding crash data and has locked the system. This is common after collision work, and it pairs naturally with the repairs handled through our auto body and collision repair service.

  • Airbag Light On With No Accident

    A steady SRS light without any crash can point to a clock spring fault, a seat sensor issue, a low battery event, or wiring trouble. The system should be scanned first so the real cause is fixed rather than masked.

  • Airbags Deployed But Light Will Not Clear

    If your airbags deployed and the light will not go off even after parts were replaced, the stored crash data has not been cleared. Replacing airbags alone does not reset the module.

  • Warning Light After Buying a Used or Salvage Vehicle

    Buying a used car with an SRS light on is a real risk, because the airbag system may be disabled. This is one reason a pre purchase vehicle inspection is so valuable before money changes hands.

  • Scanner Shows Crash Data Stored or Module Locked

    Codes such as crash data stored, event recorded, or control module locked all mean the module needs a proper reset, not just a code clear.

Why Our Airbag and SRS Reset Service Stands Out: Discover the Difference


At JC's Auto Repair Shop, our airbag and SRS module service is built to exceed your expectations and set us apart in the competitive Los Angeles market. Here's what you get with us:


  • Safety First, Always: We restore the system properly, so your airbags are ready to protect you, not just a light that has been switched off.


  • Timely Service Dispatch and Arrival: Our team stays on schedule and addresses your SRS issue without unnecessary delay.


  • Around-the-Clock Emergency Support: With 24/7 availability and same day appointments, we are here when you need us after an accident.


  • Affordable Rates and Special Offers: Competitive pricing along with valuable coupons and discounts, often a fraction of the cost of a new module.


  • Trusted Technicians: Every mechanic on our team has passed thorough background checks and drug tests, guaranteeing professional and reliable service.


Choose JC's Auto Repair Shop for airbag and SRS service that truly stands out.

Ready to Restore Your Airbag System?


Do not drive with a disabled airbag system. Call JC's Auto Repair Shop at 323 792 1777 or visit our Contact Us page to schedule your SRS module reset. Experience the difference of expert care and get your safety system back today.

Frequently Asked Questions

  • What is an SRS module reset?

    An SRS module reset clears the crash data and hard codes that your airbag control module stores after an impact. Once that data is cleared and any faults are fixed, the module unlocks, the airbag system arms again, and the warning light turns off.

  • Can an OBD scanner or the dealer just turn off my airbag light?

    Usually not after a crash. Standard OBD scanners can read codes and clear temporary soft codes, but the crash data written after a collision is stored in protected memory that ordinary tools and most dealers cannot erase. It requires a proper reset.

  • Is it safe to drive with the airbag light on?

    No. When the SRS light is on, the system is typically disabled, which means your airbags and seat belt pretensioners may not deploy in an accident. Getting it diagnosed quickly is a genuine safety matter.

  • Do I have to replace the whole airbag module?

    Often not. In most cases the module hardware is fine and it is only the stored crash data that locks it, so a reset restores it to factory condition at a fraction of the cost of a new module. Replacement is only necessary when the module itself is physically damaged.

  • Why is my airbag light on if I was never in an accident?

    A steady SRS light without a crash usually points to a clock spring fault, a seat occupancy sensor, a wiring issue, or a low voltage event. We scan the system first so the real cause is fixed rather than hidden.

  • Will replacing my airbags turn the light off?

    No. Replacing deployed airbags does not clear the crash data in the module. The module still needs to be reset before the system will arm and the light will go out.

Testimonials: What Our Clients Say About Our Mechanics


At JC's Auto Repair Shop Los Angeles, our clients' experiences speak volumes about the quality of our auto repair services. We take pride in exceeding expectations and ensuring every customer leaves our shop with a smile. Here are some testimonials from satisfied clients who have experienced our expert care firsthand

I thought I had a good mechanic but John really showed up and showed out! Excellent work, detailed information and explanations, and he even helped me with some preventative maintenance to keep me from having to come back! Hes so helpful and nice, as well as the office assistant and the prices are very good. My dad sent me here and now i refuse to go anywhere else. Thanks John!


John did an amazing job on my breaks! I last minute called him after work and it was 5 minutes from me. He was able to take me the same day and finished within 20 minutes! He literally saved me, I will be going to him again. Very nice customer service as well.






A great mechanic! John helped get my car back on the road after my hybrid battery died in less than one week. He was very helpful, transparent, and fair with everything that needed to be fixed.








These testimonials are a testament to our commitment to excellence and customer satisfaction. We're dedicated to delivering top-notch auto care that keeps our clients happy and their vehicles in peak condition. Experience the difference with JC's Auto Repair Shop Los Angeles today!